QSC TouchMix-30 Pro Windows Driver Manual
Hide thumbs
Also See for TouchMix-30 Pro:
- User manual (146 pages) ,
- Technical notes (2 pages) ,
- Quick start manual (6 pages)
Advertisement
Quick Links
TouchMix-30 Pro Windows Driver
Quick Start Guide
Introduction
The TouchMix-30 Pro Windows Driver creates an interface between a TouchMix-30 Pro mixer and a computer running the Windows 7, Windows 8, Windows 8.1, or
Windows 10 operating system (recommended). The program supports up to 32 × 32 channels of digital audio between the mixer and the computer.
Installation
1. Extract the compressed folder to a new location.
2. Open the new uncompressed folder and run Setup.
3. The Windows operating system will ask if you want to allow the program to make
changes to your device. Click Yes.
4. The Setup Welcome window will appear. Click Next > to continue.
5. Accept the default location for the driver folder or browse to another location. Click
Install.
6. The installer will copy the files to the selected location. When it is done it will present a
message that the driver has been installed on your computer. Click Finish.
Connection
1. Use a Type B USB cable to connect the mixer's USB DAW port to a USB port on your
computer.
1
Advertisement
Related Manuals for QSC TouchMix-30 Pro
Summary of Contents for QSC TouchMix-30 Pro
-
Page 1: Quick Start Guide
Introduction The TouchMix-30 Pro Windows Driver creates an interface between a TouchMix-30 Pro mixer and a computer running the Windows 7, Windows 8, Windows 8.1, or Windows 10 operating system (recommended). The program supports up to 32 × 32 channels of digital audio between the mixer and the computer. - Page 2 TouchMix-30 Pro settings Delivering audio to your computer requires the appropriate recording mode on the TouchMix-30 Pro mixer. To do this, press the Rec/Play button on the mixer, touch Record Mode and then select Multitrack DAW. NOTE: Mixer output channels 31 and 32 (2-Track Record) sends digital audio to the computer even if the mixer is not in Multitrack DAW mode.