TROUBLESHOOTING
CAUTION! Switch off and remove plug from mains before investigating fault.
Conventional trouble
Device vibrates
Device does not start:
Inferior cutting performance:
If the problem cannot be remedied on the basis of the information above, please take the device to an authorized
IVT Service Center.
ATTENTION! DO NOT ATTEMPT TO REPAIR THE PRODUCT BY YOURSELF AND DO NOT
TAMPER WITH IT! Any operation of repairing or extraordinary maintenance must be carried
out only by a qualified and authorized IVT Service Center. Do not try to modify any internal
part of the product! THIS WILL COMPLETELY VOID THE WARRANTY AND IT COULD CAUSE
SERIOUS INJURY AND DAMAGE.
Trouble reason
∙
Trimmer spool (19) is soiled
∙
Trimmer spool (19) is defective
∙
Mains voltage not applied
∙
On/Off switch (2) defective
∙
Worn carbon brushes
∙
Defective motor
∙
Trimmer spool (19) does not
have sufficient cutting line (20)
∙
Cutting line is not guided out of
the trimmer spool (19) or extends
from the trimmer spool (20) on one
side only
15
Instruction manual
Remedy
∙
Carefully clean it
∙
Replace it
∙
Check plug socket, cable,
line and plug, where appropriate,
have repaired through electrical
specialist
∙
Repair
through
service
∙
Adjust cutting line (20) length,
or replace the trimmer spool (19)
∙
Remove the trimmer spool
(19) and thread the cutting line (20)
through the openings to outside;
then mount the trimmer spool (19)
back again
EN
customer