Environmental Protection; Troubleshooting - IVT GTE-1000 Manual

3. Thread the two ends of the cutting line (22) through
the two eyelets in the cutting head (11) and insert the
trimmer spool (21).
4. Put full trimmer spool (21) into cutting head (11)
back again and close with cutting head cover (19).
5. Press the cutting line feed button (23) and pull out
both ends of cutting line (22) until they reach the outside
edge of the trimmer safety guard (12).

TROUBLESHOOTING

CAUTION! Switch off and remove plug from mains before investigating fault.
Conventional trouble
Device vibrates
Device does not start:
Inferior cutting performance:
If the problem cannot be remedied on the basis of the information above, please take the device to an authorized
IVT Service Center.
ATTENTION! DO NOT ATTEMPT TO REPAIR THE PRODUCT BY YOURSELF AND DO NOT
TAMPER WITH IT! Any operation of repairing or extraordinary maintenance must be carried
out only by a qualified and authorized IVT Service Center. Do not try to modify any internal
part of the product! THIS WILL COMPLETELY VOID THE WARRANTY AND IT COULD CAUSE
SERIOUS INJURY AND DAMAGE.

ENVIRONMENTAL PROTECTION

Tool, accessories and packaging should be sorted for
environment-friendly recycling.
The plastic components are labeled for categorized
recycling. These instructions are printed on recycled
paper manufactured without chlorine.
Trouble reason
∙
Trimmer spool (21) is soiled
∙ Trimmer spool (21) is defective
∙
Mains voltage not applied
∙
On/Off switch (2) defective
∙ Worn carbon brushes
∙ Defective motor
∙
Trimmer spool (21) does not
have sufficient cutting line (22)
∙
Cutting line is not guided out of
the trimmer spool (21) or extends
from the trimmer spool (21) on one
side only
15
Instruction manual
Recycle raw materials instead of
disposing as waste.
Remedy
∙ Carefully clean it
∙
Replace it
∙
Check plug socket, cable,
line and plug, where appropriate,
have repaired through electrical
specialist
∙ Repair through
service
∙ Adjust cutting line (22) length,
or replace the trimmer spool (21)
∙
Remove the trimmer spool
(21) and thread the cutting line (22)
through the openings to outside;
then mount the trimmer spool (21)
back again
EN
customer