Uv Installation (Rfuv Only) - Pentair PR AQUA ROTOFILTER Installation And Operation Manual

SECTION 6: INSTALLATION

6.7 UV Installation (RFUV Only)

UV modules are inserted from the top of the UV
chamber and slide down until the module is on the
top ledge of the UV chamber. See Figure 12.
Figure 12. Inserting a UV module
The aluminum lid covering the outlet chamber can
be used as a platform when installing or removing
modules. Modules are prevented from moving
side-to-side by finger locks on either side of the top
ledge of the UV chamber. See Figure 13.
Figure 13. UV chamber finger locks (1)
You may need to adjust the light block guard on
the UV module so that it sits in the guard channels
located in the UV chamber. Two set collars hold the
guard in place.
The UV module power cables should be located
on the same side as the RFUV drive assembly
when installed.
The modules plug directly into a Power Distribution
Center (PDC), which is shipped separately and must
be installed on location. Refer to the separate UV
Manual for PDC location and installation.
Installation of the Power
Distribution Center (PDC) and all
other electrical work should be
performed by a licensed, professional electrician.
PR Aqua Rotofilter™ Drum Filter Installation and Operation Manual
23