Britax CLICKTIGHT PINNACLE User Manual page 9

Britax Child Safety, Inc.
Lower Anchors with CLICKTIGHT
Before you begin:
• Check that your vehicle has lower anchors�
Use the vehicle belt (not lower connectors) for
harness mode installations with children who weigh
more than 40 lbs (18�1 kg)�
• Check that your vehicle has a top tether anchor�
The top tether MUST be used in harness mode
for children that weigh more than 65 lbs (29�5 kg)�
Britax recommends that the top tether be used at all
times when installing the child seat� Using the top
tether will improve the stability of your child seat and
reduce the risk of injury� Check your vehicle owner's
manual for tether anchor locations�
• Loosen the tether and place it over the child seat
back to keep it from becoming pinned between the
child seat and vehicle seat during installation�
• Adjust the child seat to desired position and place
forward facing on the vehicle seat�
1� Release the buckle and
open the CLICKTIGHT
to access the lower
connectors�
a� Locate the two slots
in the CLICKTIGHT
cover�
b� Squeeze the
CLICKTIGHT release
levers�
2� Route the lower connector
strap along the green
belt path and firmly press
the lower connectors
onto their adjacent lower
anchors� A click confirms
attachment�
NOTE: Verify that the strap
is not twisted.
3� Pull the end of the lower
connector strap to remove
slack�
IMPORTANT: Only
remove slack from the
lower connector webbing�
Overtightening the
webbing may prevent the
CLICKTIGHT from properly
securing�
12
FRONTIER/PINNACLE CLICKTIGHT User Guide
4� Close the CLICKTIGHT�
A click confirms the
CLICKTIGHT is secure�
NOTE: The child seat is
secure when it cannot be
moved front-to-back or
side-to-side more than
1 in. (2.5 cm) at the belt
path. If the child seat is
not secure, repeat the installation procedure or use a
different seating location.
5� Firmly press the tether
hook over a designated
vehicle tether anchor�
Remove slack�
6� Secure excess webbing
with the elastic strap�
Harness Mode: Lower Anchors with CLICKTIGHT
9 Check all connections and verify that child seat is
secure�
The child seat is secure when it cannot be moved
front-to-back or side-to-side more than 1 in� (2�5 cm)
at the belt path� If the child seat is not secure, repeat
the installation procedure or use a different seating
location�
9 Check that any excess tether webbing is contained
within your vehicle and secured in the elastic strap�
Or
Or
13