Sanyo PLC WM5500L Owner's Manual page 60

Setting
Direct on
When this function is set to On, the projector will be automatically
turned on just by connecting the AC power cord to the wall outlet.
Note:
Be sure to turn off the projector properly (see "Turning Off
the Projector" on page 24). If the projector is turned off in
the incorrect sequence, the Direct on function does not work
properly.
Pointer
You can emphasize a part of the projected image with this function.
Use the Point ▲▼ buttons to select a pattern of the Pointer (Arrow,
Finger, or Dot). (p.32)
P-timer
This function allows you to change the presentation of the P-timer
and execute it.
Select one of the following options:
Count up ............. The P-timer display 000:00 appears on the
Count down ........ The time set in the Timer setting appears on the
Timer.................... Use the Point ▲▼ buttons to set the Timer
Start ..................... It executes the count up or count down
Reset ................... Reset the P-timer values.
Exit ....................... To exit the P-timer operation.
Stop or Cancel the P-timer via Remote Control
To stop the P-timer, press the P-TIMER button.
To cancel the P-timer, press and hold the P-TIMER button for a few
seconds.
60
screen and the count starts (000:00–10:00)
screen and the countdown starts.
(1–10 Min). Only set to Count down, Timer is
active. Factory default velue is 10 Min.
function. Press the SELECT button at Start,
Start changes to Stop in the Screen Menu. At
that time, press the SELECT button at Stop
to stop Count up or Count down, and Stop
changes to Restart in the Screen Menu. Press
the SELECT button at Restart to resume
Count up or Count down.
Press the SELECT button at Reset to return to
the following value;
Count up ... "000:00"
Count down ... Timer that you set
P-TIMER
P-timer display