Gathering - Janome Air Thread 2000D Professional Instruction Manual

Machine Setting
Lower looper
pre-tension
setting slider
Left
Standard setting
needle
of tension dials
3
Stitch length dial
Differential feed
dial
Chaining finger
switch knob
Upper knife
Use both the right and left needles:
Needle
HA-1 SP No. 14 or No. 11
Needle thread Synthetic: No. 60 - 80
Upper looper
Synthetic: No. 60 - 100
thread
Lower looper
Synthetic: No. 60 - 100
thread
Fabric Medium weight, light weight
STD.
Right Upper Lower
needle looper looper
3 3
3-4
2.0
S
Activated

Gathering

Sew and check the thread tensions.
If the tension balance on the test piece is not satisfactory,
you can adjust the thread tension with the thread tension
dial.
* Adjust the differential feed dial between 1.0 and 2.0 for
gathering.
CAUTION
Make sure to turn the power switch off before
changing the needle, deactivating/activating the upper
knife or setting the chaining finger switch knob.
q Left needle thread tension dial
w Right needle thread tension dial
e Upper looper thread tension dial
r Lower looper thread tension dial
t Chaining finger switch knob
y Upper knife release knob
3
u Stitch length dial
i Differential feed dial
o Lower looper pre-tension setting slider
* Refer to page 10 for details on how to remove the
needle.
* Refer to page 11 for details on how to adjust the
stitch length.
* Refer to page 11 for details on how to adjust the
difference ratio.
* Refer to page 12 for details on how to deactivate/
activate the upper knife.
* Refer to page 13 for details on how to adjust the
chaining finger switch knob.
t
47
w e
r
q
y
u
i
o