Janome Air Thread 2000D Professional Instruction Manual page 25

⁄ 0
⁄ 1
!5
⁄ 2
!7
!6
⁄ 3
⁄ 4
i
!5
!8
⁄ 0 Raise the looper threader lever until it clicks into
place.
!5 Looper threader lever
⁄ 1 Lower the looper threader lever until it knocks into
place.
⁄ 2 Make sure that the thread comes out from the hole of
the upper looper tip.
!6 Thread end
!7 Hole of lower looper tip
NOTE:
If the thread does not come out from the hole, follow
the procedure from step ⁄ 0 again.
⁄ 3 Draw 4˝ (10 cm) of the thread under the toe of the foot,
and pull it to the rear between the foot and the upper
knife.
!8 Upper knife
⁄ 4 Return the lower threader switch lever to the "SEWING"
position.
i Lower threader switch lever
Close the looper cover and lower the presser foot
lifter.
24