Table of Contents
Advertisement
GB
Input
To switch input source from AV1, AV2, AV3, PCor DVI mode.
Wide
To select the screen mode Full, Zoom, Zoom [Caption-IN],
Normal, Natural wide,.
Refer to page 11.
Menu
To enter and exit the main menu, and sub menu.
Level Up/Down
To enter sub menus.
F/OK
To confirm the initial setting in the menu.
Picture mode selector
Press the -> . <- button repeatedly to select the following
picture mode.
Personal-Personal preference mode.
Standard-Normal viewing mode.
Dynamic-Suitable for brightly lit rooms.
Soft-Inhibit strong contrast and color, it is beneficial for eye
protection.
Eco-Suitable for dimly lit rooms and gives a cinema-like
effect.
Freeze
To switch picture still on or off.
Green
Press this button for more than 4 seconds and release,
installation mode will appear.
Remote control battery installation
Install two "AA" 1.5 volt batteries so that the "+" and "-" marks on the
batteries match the "+" and "-" marks inside the unit into the remote
control handset.
6
REMOTE CONTROL
REMOTE CONTROL
Standby
To switch the monitor on and off. Also see page 7.
Recall
To display input selection information and the Time set.
You can also select colour systems in AV3 mode as follows:
AUTO-> PAL -> SECAM -> NTSC -> NTSC4.43
It can also be automatically adjusted in PC mode by pressing
this button for twice .
Back
Used to return to the previous menu.
Up and Down
To select the next or previous item.
Bass Expander
To get an emphasised bass sound ON or OFF.
TXT/TV
To select Teletext mode.
Main/Sub Picture Swap
To swap Main and Sub picture.
ON/OFF
To switch OFF ->PIP(1) ->PIP(2) ->POP mode in turn.
Refer to page 12.
GB
Advertisement
Table of Contents
