Table of Contents
Advertisement
GB
Step : 1 Mains Connection
Connect the display unit to VGA, BNC and Scart connector as
required.
PJ-Net
1. Connect the in-line power connector to the connector attached to
the LCD monitor as shown above.
2. Connect the power cord of the LCD monitor to a wall outlet.
As this product does not have a mains On/Off switch, please
ensure your mains plug is easily accessible.
The LCD monitor is prepared for a mains voltage AC120V, 50Hz/
60Hz. To completely switch off the mains, or when the display
unit is not to be used for an extended period of time, it is advis-
able to disconnect the power cord from the power outlet.
Please use the correct mains lead supplied with the set for your
area.
.
3
Warning: To prevent injury, the unit must be securely attached to
the wall in accordance with the installation instructions.
WARNING! High voltages are used in the operation of
this set. Refer service to qualified service personnel.
Step : 2 Connections
INPUT selection
To switch between AV1, AV2, AV3, PC or DVI press the INPUT button
on your remote control repeatedly.
AV1
1.
SCART connection
RGB
2.
TTL input (5V RGB signals) into SCART terminal
Y,Pb,Pr/ RGBHV connection (AV2)
3.
This LCD monitor has a choice of Y, Pb, Pr or RGB H/V connections.
You can connect your DVD player to the Y, Pb, Pr terminals instead
of using a scart lead. This can support high definition in analogue
component form. RGB H/V can be used as a PC input via the BNC
terminals.Both options support a large range of resolutions (page 14).
INST
ALLA
TION
INST
ALLA
TION
AV3
4.
Composite (CVBS) signal input
AV3 OUT is to output the composite video signal from the VIDEO IN
so that you can connect monitors with the use of a loop through
function.
DVI-D (Digital Video Interface)
5.
This monitor has a DVI connector. This is located at the back of the
monitor next to the phono sockets. This input will support a large
range of resolutions as shown on page 14. See page 7 for details of
menu operation.
PC connection
6.
This LCD monitor has a PC connector (PC-IN D-SUB). You can
connect a PC to the LCD monitor and use it as a monitor display (see
page 9). This input will support a large range of resolutions (see page
14). Audio can be connected via the 3.5mm PC audio in socket.
7. PJ Net IN: Has the ability for PJ-NET to be connected to
control the monitor using a network.
R
L
L
R
AV2-IN
N5VW
N5VW
L
R
L
R
AV2-IN
N5VW
N5VW
GB
5
Advertisement
Table of Contents
