Chapter 2 System Status
2.9 Firmware Maintenance
2.9
Firmware Maintenance
This function performs the maintenance operation for the firmware that is managed in the ETERNUS DX/AF.
Firmware maintenance is performed to update the firmware version. The firmware can be applied after being
registered in the Bootup and Utility Device (BUD) of the CM.
•
When the application schedule for the controller firmware is being reserved, the [Apply Controller
Firmware] function is not displayed in [Action]. The [Apply Controller Firmware] function is automatically
started with the date and time that are displayed in the information field according to the application
mode that is used.
•
When the application mode is "Update & Reboot", the ETERNUS DX/AF is automatically rebooted after the
controller firmware is applied.
•
If an application schedule for the controller firmware is not reserved, the [Delete Controller Firmware
Schedule] function is not displayed in [Action].
•
If the message which indicates that the controller firmware application has been reserved disappears
before the reserved date, the reservation may be canceled automatically. In this case, reserve the appli-
cation schedule for the controller firmware again. Refer to "Apply Controller Firmware" in "ETERNUS Web
GUI User's Guide (Settings)" for details.
The following items are displayed in the Main area:
•
Current Firmware Version
The current controller firmware version is displayed.
-
VxxLyy-zzzz (Vxx: Version, Lyy: Level, zzzz: Release number)
•
Firmware Version after Restart
The controller firmware version after the next power on is displayed.
62
ETERNUS Web GUI User's Guide (Operation)
Copyright 2016 FUJITSU LIMITED
P2X0-1260-19ENZ0