Denon AVR-X1200W Service Manual page 47

3.7. TUNER STEP mode (E2 / E3 only)
3.3.1. Actions
This is a special mode for enabling reception STEP of the ANALOG TUNER to be changed.
3.7.2. Starting up
AVR-X1200W
·While holding down buttons "ZONE2 SOURCE", "DIMMER" and "STATUS" simultaneously, press the power button to
turn on the power.
AVR-S710W
·While holding down buttons "TUNER PRESET CH+", "TUNE -" and "PRESET +" simultaneously, press the power but-
ton to turn on the power.
Select the "5. TUNER FRQ SET" using the "TUNER PRESET CH +/-" button, then press the STATUS button to confirm.
3.7.3. Displays
Start up this unit in TUNER STEP mode, select the desired option using the "TUNER PRESET CH +/-" button, then enter
using the "STATUS" button.
The following information is displayed in the following order.
(a) AM9 kHz / FM50 kHz is selected
FLD
<
"TUNER PRESET CH+"
(b) AM10 kHz / FM200 kHz is selected
FLD
< A M 1 0 / F M 2 0 0
(c) Press the power button to turn off the power.
(d) Press the power button to turn on the power.
A M 9 / F M 5 0
"TUNER PRESET CH-"
"STATUS"
>
>
47