Haier Z3000B User Manual page 22

Color screen gprs
Table of Contents

Advertisement

Call timers
MOC time: you can check the total time spent on dialed calls.
MTC time: you can check the total time spent on received calls.
Clear timers: you can reset the timer.
Displaying a call cost
The "Display" feature can be turned on or off. If it is activated, both call time and cost are
displayed during a call. The default setting is off. You need PIN2 code provided by your
service provider to activate this feature.
Accumulative cost
This is feature is only available if supported by your SIM card. It allows you to access the
following operations and information:
Show cost: to display the accumulative cost of all dialed and received calls since the
last time you reset the cost meters;
Reset cost: to reset the cost meter to zero (PIN2 code required);
Balance: remaining call cost;
Show limit: the upper limit of call cost that that has been preset;
Clear limit: to cancel the upper limit of call cost that has been preset (PIN2 code
required); and
Set limit: to set an upper limit of call cost (PIN2 code required).
If the upper limit of call cost is exceeded, "Call cleared" is displayed. In this case, you cannot
place any call that is chargeable.
Charge rate
You can check and change the charge rate. The charge rate is stored in your SIM card in
decimal form.
Display rate: to display the current charge rate.
Reset rate: to reset the charge rate upon confirmation. PIN2 code required.
Set rate: to change the charge rate. PIN2 code required.
3.2 Quick settings
Through quick setting, you can take advantage of a preset parameter set under certain
circumstances. The current setting is marked with an icon on the right.
This feature allows you to customize your phone for use in five typical surroundings, that is,
normal, silent, outdoor, car and meeting. The preset parameters can be activated through
easy operation.
Each setting has a set of default values. You can change them and the resulted values will be
saved automatically. Your definition will come into effect if the parameter is user definable.
normal
Alert
type Ring + light
silent
meetings
Vibration
Vibration
outdoor
Car
Ring
+ Ring

Advertisement

Table of Contents
loading

Table of Contents