Startup Wizard - Q-See Presidio Series Quick Start Manual

6C. Turn on the NVR's power switch (if present). The NVR
may beep as it powers up. The Startup Wizard will
appear on-screen after a few minutes.
NOTE: The camera will make a faint clicking sound when the
power is activated. The cameras will take about one minute
after powering on to begin displaying on the monitor.
DISPLAY COMPATIBILITY: While the system boots, the
Q-See logo will appear. The screen may then go blank for up
to 15 seconds. If the screen doesn't reappear there may be
an issue. This NVR requires a display capable of supporting
1280 x 720 or higher.
Step 7: Startup Wizard
7A. The Startup Wizard will appear the first time you
boot your Q-See Presidio system. Select your
Language. Click OK.
IMPORTANT: An internet connection and a mobile device
(Android or iOS) will be required to complete the setup process.
9