Installation Information / Maintenance Information; Positioning/Modifications; Corrosion Protection - Wolf COB Operating Instructions Manual

6
Installation information / Maintenance
information
3 Installation information / Maintenance information

3.1 Positioning/modifications

- Your oil condensing boiler should only be installed and
modified by an approved heating contractor, as only they
have the essential knowledge to carry out such work.
- Flue gas components must not be modified.
- Never modify the drain or the safety valve.
Never close or restrict the ventilation apertures in doors
or walls when operating the boiler in open flue mode; only
start the boiler when the flue has been fully installed.
Only operate the boiler in room sealed mode, after the
room sealed system has been fully installed and the wind
protector is not covered up.
Failure to comply with this results in a risk of poisoning or
asphyxiation due to the flue gas leaking in the installation
room
Oil condensing boilers may only be installed in rooms
Note
which are protected from frost.
Never isolate the oil condensing boiler from the power
supply when outside temperatures fall below freezing!
Failure to comply results in the risk of disruption to the
installation, due to the risk of it freezing.
Do not use or store explosive and flammable materials, e.g.
petrol, thinners, paints, paper etc. inside the boiler room!
Failure to comply with this rule may lead to a risk of fire,
explosion, poisoning or suffocation!
3.2 Corrosion protection
Do not use (for cleaning, polishing etc.) or store sprays,
Note
solvents, chlorinated cleaning agents, paints, lacquer,
adhesives, salts etc. on or in the vicinity of the oil
condensing boiler. Under unfavourable conditions, these
materials may lead to corrosion in the boiler and the flue
system. Ducted vents routed through a roof may also expel
corrosive vapours.
3062548_201802