Stamina X 35-1102A Owner's Manual page 10

ASSEMBLY INSTRUCTIONS
STEP 8
There is an "L" decal on the left PEDAL CAP(101L), and an "R" decal on the right PEDAL CAP(101R). Insert
the PEDAL SHAFT(10) through the tube located on the MAIN FRAME(1). Slide the left PEDAL CAP(36L)
onto the left side of the PEDAL SHAFT(10). Slide the right PEDAL CAP(36R) onto the right side of the
PEDAL SHAFT(10). Then secure the PEDAL CAPS(36) with BUTTON HEAD BOLTS(M8x1.25x15mm)
(59) and FENDER WASHERS(M8)(60) at both ends of the PEDAL SHAFT(10). You need to use two
Allen Wrenches to tighten the BUTTON HEAD BOLTS(M8x1.25x15mm)(59) at both ends of the PEDAL
SHAFT(10) at the same time.
STEP 9
Install two AA batteries into the METER(13), the batteries are not included. See page 11 for detailed
battery installation instructions. Insert the METER(13) onto the METER PLATE(48). Connect the SENSOR
WIRES(15) to the connecting wires of the METER(13).
13
L
15
48
59
60
101L
R
1
10
60
59
101R
10