Boot Sequence; Swap Floppy Drive; Boot Up Floppy Seek; Boot Up Numlock Status - MSI MS-5156 Manual

Boot Sequence

This category determines which drive the computer searches first
for the disk operating system (i.e., DOS). The settings are A,C,SCSI/
C,A,SCSI/C,CD-ROM,A/CD-ROM,C,A/D,A,SCSI/E,A,SCSI/F,A,SCSI/
SCSI,A,C/SCSI,C,A/C only. Default value is A,C,SCSI.

Swap Floppy Drive

Switches the floppy disk drives between being designated as A
and B. Default is Disabled.

Boot Up Floppy Seek

During POST, BIOS will determine if the floppy disk drive installed
is 40 or 80 tracks. 360K type is 40 tracks while 720K, 1.2M and 1.44M are all
80 tracks.
Enabled(default) BIOS searches for floppy disk drive to determine
Disabled

Boot Up NumLock Status

The default value is On.
On (default)
Off
Boot Up System Speed
This selects the speed that the system will run at immediately after
power up.
High (default)
Low
if it is 40 or 80 tracks. Note that BIOS can
not tell from 720K, 1.2M or 1.44M drive type as
they are all 80 tracks.
BIOS will not search for the type of floppy disk
drive by track number. Note that there will not
be any warning message if the drive installed is
360K.
Keypad is numeric keys.
Keypad is arrow keys.
Sets the speed to high.
Sets the speed to low.
3-10
®