Entering Your Atis Id; Enabling And Disabling Atis Mode - Raymarine RAY53 Installation & Operation Instructions

5.14 Entering your ATIS ID

A unique ATIS ID must be entered before ATIS mode
can be enabled.
From the Main menu.
1. Select Set-up.
2. Select ATIS set-up.
3. Select ATIS ID.
Not set will be displayed if no ATIS ID has been set.
The first digit is set to a '9' and cannot be changed,
this is because all ATIS IDs start with a '9'.
As most ATIS IDs consist of a '9' followed by your 9
digit MMSI number; if your radio already has an MMSI
number the ATIS ID will be pre-filled in this format.
4. If the ATIS ID has been pre-filled, check it carefully
against your issued ATIS ID.
5. To enter your ATIS ID manually, use the Rotary knob
or the Channel Up and Channel Down buttons on
a Raymic handset to cycle through the available
numbers and press OK to confirm each number and
move to the next digit.
You should only enter the unique 10 digit ATIS ID
provided by your licensing authority.
6. Press the Back button at any time to edit digits you
have already entered.
50
81381-1-Ray53_63_73_Install_and_Ops_PRINT.pdf 50
7. Press and hold the OK button to display options to
Move cursor back and forward through the digits.
8. When the final digit is confirmed select DONE.
Example
9. The ATIS ID is displayed onscreen, check that it is
correct, then:
i. Select Yes – Save, or
ii. if the number entered is not correct select No –
Retry.
Caution: MMSI and ATIS ID
entry
You can only enter the MMSI number and
ATIS ID once!
If you store an incorrect MMSI number or
ATIS ID in your product, it will have to be
reset by an authorized Raymarine

Enabling and disabling ATIS mode

ATIS is a European system used on some inland
waterways. A unique ATIS ID must be entered before
ATIS mode can be enabled.
With ATIS mode enabled the radio's region will be
fixed to the INT (international) frequency band and the
following functions are disabled:
• DSC functions
• Watch Mode
• Scan Mode
• High/low power is restricted on certain channels
From the Main menu.
1. Select Set-up.
2. Select ATIS set-up.
3. Select ATIS.
If no ATIS ID has been set then you will be requested
to enter one before ATIS mode is enabled.
4. If an ATIS ID has already been set then select On to
enable ATIS mode or Off to disable ATIS mode.
® dealer.
6/13/2018 2:30:13 PM