Raymarine RAY53 Installation & Operation Instructions page 29

the location of the screw holes and the center hole
on the mounting panel.
To ensure that the handset's connector points down
when connected, orientate the mounting plate so
that the lanyard grove is pointing straight up.
3. Drill the mounting holes using a suitable size drill bit.
4. Drill the center hole using a 25 mm (1 in.) hole cutting
saw.
5. Pull the connector end of the cable through the hole
in the mounting surface.
6. Place the Mounting plate gasket over the end of the
connector.
7. With the recessed side facing away from the
mounting panel, place the Mounting plate over the
end of the connector.
8. Place the lanyard end of the Splash-proof dust cap
over the connector, ensuring the lanyard sits in the
recess in the Mounting plate.
9. Place the Mounting plate nut over the connector and
tighten clockwise using a 13/16 in. (21 mm) socket
wrench, being careful not to damage the plastic nut
by overtightening.
10. Secure the Mounting plate to the mounting surface
using the supplied screws.
11. Attach the Handset / Fistmic connector to the cable
connector and rotate the locking collar clockwise to
secure.
12. Connect the opposite end of the cable to the
required connector either on the Base station or
to another pass-through panel mounting plate
connector.
Installation
81381-1-Ray53_63_73_Install_and_Ops_PRINT.pdf 29
Note:
Drill bit, tap size and tightening torque is dependent
on the thickness and type of material the unit is to
be mounted on.
29
6/13/2018 2:30:11 PM