Description
2.7 How do you program an encoder that has not been loaded with data?
You can also determine the component number from the topology view.
1
2
Make a note of the component number.
6. Switch to the CU expert list and change the following parameters:
– p4690: SMI spare part component number 12
– p4691: SMI spare part save/download data: 2 Download SMI data
7. Wait for the feedback signal in parameter p4691:
– p4691: SMI spare part save/download data: 9 SMI data downloaded and power on...
– As soon as the value 9 is in the parameter, you can switch-off/switch-on the drive
40
Designation of the encoder that has been replaced
Encoder component number
required
(=POWER ON).
Replacing an encoder for SIMOTICS S-1FK7 G2, S-1FG1 and S-1FT7
Service Manual, 01/2018, A5E34676237B AC