Installing The Water Dispenser Line - Samsung SRS579NP User Manual

INSTALLING THE WATER DISPENSER LINE

1) For the ice maker to operate automatically, water pressure of 1.4 - 4.5 kgf/cm
required. (It should be possible to fill a disposable paper cup (approximately 180 cc)
within 10 seconds.)
2) The water tube can be cut to the required length.
Make sure that the tube is not bent.
3) Place the water tube away from any sources of heat.
4) The purifier is for filtering only. It does not sterilize or destroy any micro-organisms.
5) If the fridge/freezer is installed in the area with low water pressure (below
1.4 kgf/cm ), you may purchase and install a booster pump to compensate for the
2
low pressure.
6) The service life of the purifier depends on the condition of the usage, but we recom-
mend that you change it every six months.
You should, therefore, install it easily in a location.
7) To supply water of the storage tank inside the fridge, press the cold water button for
about two or three minutes until cold water runs from the cold water outlet.
8) To avoid any leakage, seal every joined area using sealing tape.
9) The water tube should be connected to the cold water tap.
Checking the Parts (Model with the purifier)
Tapping screw x 12EA
Purifier
Note:
The purifier is optional and available at
extra cost from your dealer.
Water tube
11
Sealing tape
Clip A x 8EA
Purifier lock station
Tightening band
is
2