Samsung SCX-6x22 User Manual page 85

Message Meaning
LSU Hsync Error A problem has
Cycle Power occurred in the LSU
(Laser Scanning
Unit).
Main Motor There is a problem
Locked in the main motor.
Mail Exceeds The mail size is
larger than the
Server Support
supported size by
SMTP server.
Memory Full The memory is full.
MP Tray There is no paper in
the multi-purpose
Paper Empty
tray.
Network Error There is a problem
with the network.
[No Answer] The receiving fax
machine has not
answered after
several redial
attempts.
Not Assigned The one-touch dial
or speed dial
number you tried to
use has no number
or email address
assigned to it.
[No Paper] The paper in the tray
Add Paper has run out.
One Page is Single page data
exceeds the
Too Large
configured mail size.
Open Heat Error There is a problem
Cycle Power in the fuser unit.
Suggested solutions
Unplug the power
cord and plug it back
inches. If the problem
persists, please call
for service.
Open and then close
the front cover.
Divide your mail or
reduce the resolution.
Delete unnecessary
fax jobs and
retransmit after more
memory becomes
available.
Alternatively, split the
transmission into
more than one
operation.
Load paper in the
multi-purpose tray.
See page 5.6.
Contact your network
administrator.
Try again. Make sure
that the receiving
machine is
operational.
Enter the number or
email address
manually using the
number keypad or
store the number or
address.
Load paper in the
tray. See page 5.5.
Reduce the resolution
and try again.
Unplug the power
cord and plug it back
in. If the problem
persists, please call
for service.
14.8
Message Meaning
Operation Not You are in the Add
Assigned Page/Cancel Job
operation, but there
are no jobs stored.
Over Heat Error There is a problem
Cycle Power in the fuser unit.
Paper Jam 0 Paper has jammed
Open/Close Door in the feeding area
of the tray.
Paper Jam 1 Paper has jammed
Open/Close Door in the fuser area.
Paper Jam 2 Paper has jammed
Check Inside in the paper exit
area.
Power Failure Power has turned off
then on and the
machine's memory
has not been back
up.
Replace Drum The drum cartridge
is at the end of its
life.
Retry Redial? The machine is
waiting for a
specified time
interval to redial a
previously busy
station.
Scanner locked The scanner module
is locked
Self Diagnostic The LSU (Laser
LSU Scanning Unit) in
your printer is
checking some
problems detected.
Self Diagnostic The engine in your
Temperature machine is checking
some problems
detected.
Send Error There is a problem
in SMTP
(AUTH)
authentication.
<Troubleshooting>
Suggested solutions
Check the display to
see if there are any
scheduled jobs.
Unplug the power
cord and plug it back
in. If the problem
persists, please call
for service.
Clear the jam. See
page 14.2 and
page 14.3.
Clear the jam. See
page 14.4.
Clear the jam. See
page 14.4.
The job which you
were trying to do
before the power
failure must be
completely re-done.
Replace the drum
cartridge. See page
13.5.
You can press OK to
immediately redial, or
Stop/Clear to cancel
the redial operation.
Unlock the scanner
and press Stop/
Clear.
Please wait a few
minutes.
Please wait a few
minutes.
Configure the
authentication setting.