Samsung SCX-6x22 User Manual page 84

Message Meaning
Duplex Jam Paper has jammed
Open/Close Door during duplex
printing.
File Access Login to the network
Denied server was
successful.
However, access to
the file on the
network server was
denied.
File Name Exist The file name you
have entered
already exists.
File Name Over The file names you
Limit can use are from
doc001 to doc999.
However, all file
names are used
already.
Fuser Door Open The fuser door is not
securely latched.
Global Address When the device is
Not Found unable to locate the
given address of the
Global server.
Global Query Size This is an error
Exceeded message and
displays when the
global query size
has been exceeded.
Global Server When there is a
Auth Failed authentication fail
while connecting to
the global server this
message displays.
Global Server This error message
Communication displays when there
Error is a communication
error between the
global server and
the device.
Suggested solutions
Clear the jam. See
page 14.6.
Change the server
settings.
Enter a different file
name.
Delete unnecessary
files.
Open the rear cover
and close the fuser
door until it locks into
place.
For the location of the
fuser door, see
page 14.4.
Check the search ID.
There are too many
search results. Refine
your search by
entering more letters.
Contact a LDAP
Server administrator.
Check the
authentication
account and
password.
Try again.
Contact a LDAP
Server administrator.
14.7
Message Meaning
Global Server Not When no global
Configured server is configured,
this message
displays.
Global Server not When the device is
found unable to find the
Global server.
Group Not You have tried to
Available select a group
location number
where only a single
location number can
be used, such as
when adding
locations for a
Multiple Send
operation.
[Incompatible] The machine has
received a fax from
which is registered
as a junk fax.
Invalid Server The server address
Address you have entered is
invalid.
Line Busy The receiving fax
machine did not
answer or the line is
already engaged.
[Line Error] Your machine
cannot connect with
the receiving fax
machine or has lost
contact because of a
problem with the
phone line.
Low Heat Error There is a problem
Cycle Power in the fuser unit.
LSU Motor Error A problem has
Cycle Power occurred in the LSU
(Laser Scanning
Unit).
<Troubleshooting>
Suggested solutions
Check the LDAP
server configuration
settings.
Check the LDAP
server address, The
LDAP server address
is incorrect, or the
server has failed.
Use a speed dial
number or dial a
number manually
using the number
keypad.
The received fax data
will be deleted.
Reconfirm junk fax
setup, see page 10.2.
Enter the correct
server address.
Try again after a few
minutes.
Try again. If the
problem persists, wait
an hour or so for the
line to clear and try
again.
Or, turn the ECM
mode on. See
page 10.1.
Unplug the power
cord and plug it back
in. If the problem
persists, please call
for service.
Unplug the power
cord and plug it back
inches. If the problem
persists, please call
for service.