Table of Contents
Advertisement
Problem
Irregular faded
patches of print.
Black staining.
Character voids.
5.
Troubleshooting
12
Solving Print Quality Problems
If you have any problems with the printed output of your ML-6100, refer
to Table 5.2 for suggested remedies.
Note: The causes listed in Table 5.2 are probable causes only, and may not repre-
sent all of the possible cases which may occur under actual operating con-
ditions. If you experience a problem which does not seem to fall under any
of the cases listed in this table, or if you are concerned about any other
aspect of printer operation, contact the your nearest Samsung dealer.
Possible Cause
There is a paper quality problem.
Toner may be unevenly distributed.
There is a paper quality problem.
A toner cartridge from another printer
has been installed.
The printer requires a print quality
adjustment.
The paper may be too dry.
Table 5.2
Use only paper that meets the
specifications required by the printer.
Remove the toner cartridge and
shake it gently to evenly distribute
the toner. Then replace the cartridge
back into the printer.
Use only paper that meets printer
specifications. See the section
"Selecting Print Media" (page 3.1).
Always use the same toner cartridge
with the same printer. Using a
cartridge that has already been used
in another printer may not give
satisfactory results.
Press and hold the control panel
button for ten seconds until all lights
remain steadily lit, then let go of the
button. The printer will perform the
print quality adjustment. After
cleaning, one cleaning sheet prints.
Try printing with a different batch of
paper.
Remedy
Advertisement
Table of Contents
