ML-6060/1650 Technical Instructions Photo 4 Step 3 Using a Philips screwdriver remove the two screws located on top of the cartridge Notes next to the toner hopper. (See Photo 4) Photo 5 Step 4 Pry the front of the toner hopper reservoir back.
ML-6060/1650 Technical Instructions Photo 9 Step 8 Side the cartridge end cap from the side of the cartridge. (See Photo 9) Notes Photo 10 Step 9 Pull the metal gear housing plate from the side of the cartridge. (See Photo 10) NOTE: Two gears may stay attached to the gear housing end plate.
Page 4
ML-6060/1650 Technical Instructions Photo 14 Step 12 Rotate the cartridge 180°. Remove the Notes three screws that hold the contact end cap to the cartridge. (See Photo 14) Photo 15 Step 13 Slide the end cap from the side of the car- tridge.
Page 5
ML-6060/1650 Technical Instructions Photo 20 Step 16 Lift up on the waste hopper and remove the hopper from the cartridge. Notes (See Photo 20) Photo 21 Step 17 If the drum axle has already been removed lift out the drum. If the drum axle cannot...
Page 6
ML-6060/1650 Technical Instructions Photo 25 Step 20 Notes Dump out the waste hopper. Clean the waste hopper using dry compressed air or a vacuum. Step 21 Apply padding powder to the wiper blade. Place the blade onto the waste hopper.
Page 7
ML-6060/1650 Technical Instructions Photo 30 Step 27 Remove the end cap from the hopper. Notes (See Photo 30) Photo 31 Step 28 Slide the developer roller out from the side of the cartridge. (See Photo 31) Photo 32 Step 29 Clean the developer roller using a dry lint free cloth.
Page 8
ML-6060/1650 Technical Instructions Photo 35 Step 33 Place the developer roller drive gear onto the rollers axle. (See Photo 35) Step 34 Photo 36 Photo 37 Apply padding powder to the drum. Install the drum into the cartridge. (See Photo 36)
Page 9
ML-6060/1650 Technical Instructions Photo 41 Step 38 Install the white bearing onto the supply roller axle. Step 43 (See Photo 41) Slide the contact end cap onto the cartridge. Install the three screws that hold the end cap in place.
Page 10
ML-6060/1650 Technical Instructions Photo 48 Step 46 Slide the tail of the seal under the toner Notes hopper sealing end foam and out through the seal exit port on the side of the cartridge. (See Photo 48) Photo 49 Step 47 Lock the latches on the back of the cartridge and toner hopper reservoir.
Page 11
In July of 2000, NEC released a new family of printers, the SuperScript 1400, 1450, and the 1450N all using a new Samsung ML-6060 engine. Two months later Xerox and IBM released the Xerox DocuPrint P1210 and the IBM InfoPrint 12 each using the same Samsung engine.