VIA Amplifiers
VIA2004
1. Power Inlet‐ The unit should be connected to a suitable mains electricity supply
using an earthed Neutrik PowerCon connection power lead. The device has a switch
mode power supply that is capable of operating with a nominal mains voltage of
100V to 230V, 50/60Hz without re‐configuration.
2. Loudspeaker Connectors‐ The amplifier Neutrik Speakon™ outputs. Connect the
loudspeaker to the 1+ and 1‐ terminals. CH1 also carries the (duplicated)
loudspeaker output for channel 2 on terminals 2+ and 2‐. CH3 also carries the
(duplicated) loudspeaker output for channel 4 on terminals 2+ and 2‐.
3. Analogue Audio Input Connectors‐ All audio connections are fully balanced and
wired: pin‐1 to ground (as required by the AES48 standard), pin‐2 hot & pin‐3 cold.
4. Analogue Audio Link Connectors‐ Carries a duplicate (parallel) connection from
that channel (to link to another amplifier for example).
VIA Amplifiers User Guide V1.0
USER GUIDE
21