VIA Amplifiers
Rear Panel
VIA2502
1. Power Inlet‐ The unit should be connected to a suitable mains electricity supply
using an earthed Neutrik PowerCon connection power lead. The device has a switch
mode power supply that is capable of operating with a nominal mains voltage of
100V to 230V, 50/60Hz without re‐configuration.
2. Loudspeaker Connectors‐ The amplifier Neutrik Speakon™ outputs. Connect the
loudspeaker to the 1+ and 1‐ terminals. CH1 also carries the (duplicated)
loudspeaker output for channel 2 on terminals 2+ and 2‐.
3. Analogue Audio Link Connectors‐ Carries a duplicate (parallel) connection from
that channel (to link to another amplifier for example).
4. Bridge switch‐ Switches the amplifier to operate in bridge mode.
5. Analogue Audio Input Connectors‐ All audio connections are fully balanced and
wired: pin‐1 to ground (as required by the AES48 standard), pin‐2 hot & pin‐3 cold.
VIA Amplifiers User Guide V1.0
USER GUIDE
20