Epson SureLab D700 Operation Manual page 78

Code
E-9901(xxxx), A printer system error occurred.
E-9902(xxxx)
Delete all print jobs remaining in the operating system's print
queue.
Turn the printer off. Check if there is any paper remaining
inside the printer, and then turn the printer back on.
Contact service support if the error continues to occur.
I-5201 Amount of data in print jobs sent to printer nearly at maximum
limit.
Stop sending the current print job and send the remaining
pages as another print job.
W-2206 You have not installed genuine Epson ink cartridges.
xxxx
Information about ink levels may not be displayed, and use of
non-genuine ink is recorded for possible use in service support.
For optimum quality and reliability Epson recommends using
genuine Epson ink.
W-2207 A non-genuine or refilled cartridge has been detected. Ink
levels may not be shown because of unknown ink volume.
W-2208 A non-genuine or refilled cartridge has been detected. Ink
levels may not be shown because of unknown ink volume.
Troubleshooting
Message
78
What to do
Restart the printer.
If the error persists, contact Epson
support.
The print job is too large.
Split up the data and try printing
again.
This printer is developed for use with
genuine ink cartridges. If you use
non-genuine cartridges, the print
result may be faint, or the ink
remaining may not be detected
normally. We recommend using
genuine Epson products.