Epson SureLab D700 Series ® ® Start Here Remove all the packaging materials and tape from inside the roll paper feeder. IMPORTANT: Before using this product, make sure you read these instructions and the safety instructions in the online Operation Guide.
Install ink cartridges The printer starts charging the ink. This takes about 20 minutes. Remove the ink cartridges from their packages. Caution: Do not turn off or unplug the printer while the power light is flashing. Also, do not open the ink Caution: Do not touch the green chip on top of the cartridge.
Page 3
Remove the scrap paper box. Insert the leading edge of the paper into the paper feed slot until the paper light turns on. Note: Make sure the leading edge is cut straight across to avoid paper feeding problems. Grip the handle to release the roll paper feeder and pull it out. Push the roll paper feeder back into the printer.
You can now remove the roll paper spindle from the printer. EPSON and SureLab are registered trademarks and EPSON Exceed Your Vision is a registered logomark of Seiko Epson Corporation. Epson Preferred is a service mark of Epson America, Inc.