Installing Option Modules - Siemens SIPART PS2 6DR5xx0 series Compact Operating Instructions

Procedure
NOTICE
The following is applicable for the "flameproof enclosure" version:
A friction clutch is provided on the outside of the positioner axis. Change the work area using this friction clutch.
•
Do not open the flameproof enclosure of the positioner in explosion-prone atmospheres.
•
Fix the setting acquired by initialization as follows:
1. Make sure the gear latch
2. Make sure the transmission ratio selector
3. Fix the transmission ratio with the gear latch
①
until the gear latch
④
to 90° . The transmission ratio is locked.
Note
Changing the setting of the transmission ratio selector
The setting of the transmission ratio selector
③
position .
4. To fix the friction clutch
5. Use the screwdriver to turn the friction clutch gear latch
locked.
3.6

Installing option modules

A number of option modules are provided for the positioner. Different option modules are available depending on the version
of the device. Only the available option modules are listed below.
For additional information and the corresponding safety notes to be observed when installing the option modules, refer to the
detailed operating instructions for your respective device version.
Option modules in standard and intrinsically safe versions
The following option modules are available:
● Position feedback module
● Alarm module
● SIA module
● Mechanical limit switch module
● EMC filter module
● NCS sensor
● Internal NCS module
Option modules in "flameproof enclosure" version
The following option modules are available:
● Position feedback module
● Alarm module
● Internal NCS module
SIPART PS2 (6DR5...)
A5E03436620-AB, 01/2017
①
is in neutral position
⑤
is in the correct position.
①
locks. Turning right locks the transmission ratio to 33°
⑤
⑥
insert a standard approx. 4 mm wide screwdriver in the friction clutch gear latch
③
. The neutral position is between 33° and 90°.
①
. Turn the gear latch
can only be changed effectively if the gear latch
⑦
counterclockwise until it engages. The friction clutch
with a standard approx. 4 mm wide screwdriver
②
. Turning left locks the transmission ratio
①
is in the neutral
⑦
.
⑥
is
13