Error Messages - Asko WMC64P Operating Instructions Manual

Troubleshooting

Error messages

If an error occurs during the program a message
is shown on the display. To exit the message after
taking measures, turn the machine off and then
back on.
The error messages that may be shown in the
display are:
Close the door
Close the washer door and the program will start.
Over flow fault
1. Shut off the water tap.
2. See "Water outlet fault".
Water outlet fault
Check:
• that no objects are stuck in the drainage hose
outlet.
• that the drainage pump is not blocked by
foreign objects. Clean the pump. See the "Care
and cleaning" chapter.
• that there are no kinks in the drainage hose.
Press the Door opening button (key symbol) to
empty the machine of water before opening the
washer door. If this does not resolve the problem,
call the service division.
Water inlet fault
Check:
• that the tap on the water pipe is open.
• that the filter in the machine's water inlet is not
blocked.
Action:
1. Shut off the water tap.
2. Unscrew the hose.
3. Clean the filter in the inlet valve on the
machine.
4. Screw the hose back on.
5. Turn on the tap and check for leaks.
6. Run the program again to check if the fault is
fixed.
7. If this does not resolve the problem, call the
service division.
Security fault
Call the service division!
Wash motor fault
Call the service division!
Unbalance
The machine stops the spin cycle if there is too
much imbalance. The washing machine restarts
the spin cycle and hopefully the washing is better
distributed in the drum. This procedure can be
repeated up to 10 times. If the machine still fails
to find a good balance, the program jumps to the
next step.
The error message requires no action.
19