Raymarine AXIOM XL 16 Installation Instructions Manual page 86

• Cable clips (not supplied) should be used to support the cable and ferrite.
• If you need to remove a ferrite for any reason, ensure it is replaced in its original location before using the product.
• If the ferrite moves freely once fitted to the RayNet cable use cable ties (not supplied) above and below the
ferrite to secure in place.
Connections to other equipment
Requirement for ferrites on non-Raymarine cables
If your Raymarine equipment is to be connected to other equipment using a cable not supplied by Raymarine, a
suppression ferrite MUST always be attached to the cable near the Raymarine unit.
Axiom XL 24 above decks installation requirements
Note:
The installation requirements below only apply to the Axiom XL 24 when being installed in an above decks
environment.
The Axiom XL 24 is designed to operate in ambient temperatures of up to 55°C / 131°F and with display surface
temperatures of up to 65°C / 149°F. However, when the display is exposed to prolonged, direct sunlight the surface
of the Axiom XL 24 may exceed these temperatures. This may cause the LCD to blackout temporarily, until the
surface temperature falls to within normal limits. To help mitigate this occurrence it is recommended that when
installing in an above decks environment the Axiom XL 24 is mounted in a location protected from direct sunlight
e.g.: underneath a hardtop or Bimini (canvas).
Other factors that can help to reduce the surface temperature of your display include ensuring sufficient airflow
around the display and reducing the LCD's brightness level.
2
Axiom XL supplementary information