Mounting - Raymarine AXIOM XL 16 Installation Instructions Manual

1. Starting at the bottom centre, affix the gasket tape to the MFD.
2. Remove the paper backing from the tape before going around the corners, ensuring that the tape
remains tort and no air gap exists between MFD and tape.
3. When you reach the end, leave a small overlap to ensure that no gap exists between the ends of
the gasket when it is compressed.
Note: The supplied gasket tape provides a seal between the unit and a suitably flat and stiff
mounting surface or binnacle. The gasket should be used in all installations. It may also be
necessary to use a marine-grade sealant if the mounting surface or binnacle is not entirely flat
and stiff or has a rough surface finish.

Mounting

Axiom XL MFDs can be surface or flush mounted from the rear of the mounting surface.
Installation 23