Raymarine AXIOM XL 16 Installation Instructions Manual page 85

Axiom XL supplementary information
Warning: Product installation and operation
• This product must be installed and operated in accordance with the instructions provided.
Failure to do so could result in personal injury, damage to your vessel and/or poor product
performance.
• Raymarine recommends certified installation by a Raymarine approved installer. A certified
installation qualifies for enhanced product warranty benefits. Contact your Raymarine dealer
for further details, and refer to the separate warranty document packed with your product.
Technical accuracy
To the best of our knowledge, the information in this document was correct at the time it was produced. However,
Raymarine cannot accept liability for any inaccuracies or omissions it may contain. In addition, our policy of
continuous product improvement may change specifications without notice. As a result, Raymarine cannot accept
liability for any differences between the product and this document. Please check the Raymarine website
(www.raymarine.com) to ensure you have the most up-to-date version(s) of the documentation for your product.
Cable suppression ferrites
To ensure optimum EMC performance and to comply with applicable EMC regulations any RayNet cables connected
to this product must have a suppression ferrite fitted.
Three suppression ferrites are included with your display, one for each RayNet connection.
Fit a ferrite to each RayNet cable as shown below:
Document number: 82400-2 AB;9764;2018-07-19T14:54:01
Date: 07-2018