Install the IFP bleed screw into the IFP. The bleed screw should be
20
submerged in oil.
Remove the damper body bleed screw from the damper body eyelet,
21
and rotate the damper body away from you.
Insert a small hex wrench through the slot next to the 33 or 39 mm
22
mark on the IFP Height Tool, depending on your shock stroke.
45 - 65 mm shock stroke: 33 mm
75 mm shock stroke: 39 mm
Use the IFP bleed tool to slowly push the IFP into the reservoir to the
appropriate depth for your shock stroke.
⚠ CAUTIO N- E YE HAZARD
Do not look directly into the reservoir or at the damper body as you
push on the IFP. Oil may be ejected from the IFP reservoir or damper
body if you push the IFP down too fast. Wear safety glasses.
T10 TORX®
T10
IFP Height Tool
45-65 mm shock stroke: 33 mm
Small hex wrench
75 mm shock stroke: 39 mm
Shock Assembly and Bleed
46