Remove the inner o-ring, located at the base of the threads in the seal
8
head/air piston.
Install a new o-ring, and apply a liberal amount of grease to the o-ring
and bushing.
Install the seal head/air piston onto the damper shaft.
9
Clamp the damper shaft into the RockShox® Rear Shock Vise Block.
10
To prevent damage to the seal head/air piston, position the shaft in the
vise so that the piston and IFP reservoir are clear of the vise jaws.
Install the main piston assembly that was removed in step 5 onto the
11
damper shaft. Squeeze the shims and center the shim stack on top of
the main piston.
If desired, install a new piston tune. Refer to the RockShox spare parts
catalog on www.sram.com.
Be sure to keep the main piston assembly parts in the same order.
If the shims are not centered and in the correct order, the shock will not
perform properly.
NOTI CE
NOTI CE
Piston Service
39