SRAM RockShox Super Deluxe Service Manual page 34

Remove the spring from the cam and clean the cam with a rag.
4
Do not spray isopropyl alcohol on the cam when o-rings are installed.
Isopropyl alcohol can cause the o-rings to become brittle and break.
Apply a thick layer of grease to the cam.
5
Apply a thick layer of grease to the inside and outside of the new
6
remote spring, then install the spring onto the cam with the spring tang
in the spring tang hole.
Install the cam and spring into the cam housing, and rotate the cam
7
until the spring tang falls into the tang hole. The cam should be flush
with the end of the cam housing.
NOTICE
RockShox® Dynamic Seal Grease
RockShox Dynamic Seal Grease
Remote Spring Replacement - RTR Only 34