Loading Updated Databases - Garmin G1000 Reference Manual

Appendix

LOADING UPDATED DATABASES

CAUTION: Never disconnect power to the system when loading a database.
Power interruption during the database loading process could result in main-
tenance being required to reboot the system.
NOTE: When loading database updates, the 'DB Mismatch' message will
be displayed until database synchronization is complete, followed by turning
system power off, then on. Synchronization can be monitored on the AUX-
SYSTEM STATUS Page.
In some cases it may be necessary to obtain an unlock code from Garmin in order
to make the database product functional. It may also be necessary to have the system
configured by a Garmin authorized service facility in order to use some database
features.
If an error occurs during synchronization, an error message will be displayed,
followed by the affected display in the Sync Status section of the Database Window. If
synchronization completes on one display, but an error occurs on another, the error
message will be displayed with the affected displays listed after it. When an error
message is displayed, the problem must be corrected before synchronization can be
completed. A power cycle is required to restart synchronization when 'Card Full' or
'Err' is shown.
Error Message
Canceled
Card Full
Err
Timeout
Loading Garmin Database Updates
1) With system power OFF, remove the MFD database card from the bottom
card slot of the MFD.
2) Update the Garmin databases on the MFD card.
3) Insert the MFD database card into the bottom card slot of the MFD.
108
Garmin G1000 Cockpit Reference Guide for the Cessna Citation Mustang
Database synchronization has been canceled by removing the
bottom SD card in display being updated
SD card does not contain sufficient memory
Displayed for all other errors that may cause the synchronization
process to be halted
System timed-out prior to the database transfer completing
Description
190-00600-04 Rev. A