Interlogix 600-1046-95 Installation Instructions

OEM Transceiver Module with Crystal
Transmitter Installation Instructions
Introduction
The OEM transceiver modules are compatible with Interlogix
wireless transmitters and receivers. The modules have an
onboard receiver and transmitter, microprocessor, and
connection for a daughter board. The microprocessor controls
the receiver and transmitter, providing antenna switching and
AGC functions. It also analyzes the data from the receiver,
validates incoming packets, and returns packets to the
controlling device when polled. A daughter board, which
communicates with the module via an 8-pin header, can be
added to implement a variety of functions.
Each module encapsulates the receiver and transmitter
functions and formats and presents a common interface to the
daughter board. Therefore, even though protocols vary among
the Interlogix radio frequencies used around the world, the
interface is the same to the daughter board.
Installation guidelines
Observe the following guidelines when installing the OEM
transceiver module:
• Allow at least 9 inches (22.9 cm) of clearance above the
enclosure for the antennas.
• Avoid mounting locations that expose the module to
moisture.
• Avoid areas with excessive metal or electrical wiring
including furnace and utility rooms. If unavoidable, mount
on or near metal with the antenna extending above the
metallic surfaces as shown in
Figure 1. Mounting on or near metal
METAL
P/N 466-2236 • REV C • January 2011
Figure 1.
METAL
• While a transmitter may have an open-air range of 1000 ft.
(300 m) or more, the installation site can have a significant
effect on the transmitter range. Changing the sensor
location may help overcome adverse wireless conditions.
Installation
600-1029 enclosure
To mount the 600-1029 enclosure, follow the installation
instructions provided with the enclosure.
600-0131 daughter board
To attach the 600-0131 daughter board, follow the installation
instructions provided with the daughter board.
600-1046-95 OEM transceiver module
To mount the OEM transceiver module onto the back plate of
the 600-1029 enclosure, do the following:
1. Insert the antennas into the antenna shrouds
Caution: You must be free of static electricity before handling
circuit boards. Wear a grounding strap or touch a bare metal
surface to discharge static electricity.
2. Gently slide the top of the circuit board under the two top
latches.
3. Snap the circuit board in at the bottom latch to secure it in
place as shown in Figure
(Figure
2.
2).
1