Olivetti FK-507 Service Manual page 85

7. Soft Switch
MODE
Bit:
301
Bit
7 Select upper limit of cut-off
length after printing:
6
When a received document is
5
longer than the print paper
and if the excess length is
shorter than that specified
here, it is cut off.
If it is longer than that value
specified with these bits, it is
split into multiple pages. This
feature is enabled when the
following 2 conditions are sat-
isfied:
• When printing a received
document
• When bit 1 of this mode is 1
<*>
4 Select upper limit of reduction
ratio of received document:
3
When a received document is
2
longer that the print paper, it
will be reduced to fit the paper
with the upper limit specified
with these bits. This feature is
enabled when the following 2
conditions are satisfied:
• When printing a received
document
• When bit 1 of this mode is 0
Example: The reduction is
100 to 90% when "90%" is
specified.
If the document will not fit
within a printable range at the
maximum reduction ratio
specified here, the excess
length portion is divided. <*>
1 Select cut off/reduction of
received document:
This bit specifies cutting off or
reducing a received docu-
ment that is longer than the
print paper.
(This feature is enabled when
printing a received docu-
ment.) <*>
78
Factory setting bit
7 6 5 4 3 2 1 0
0 0 0 1 1 0 0 1
Feature
0
Bit 7-5:
Bit 4-2:
Reduc-
tion
Service Manual
Field Service Ver. 2.0 Dec. 2008
HEX: 19 (For U.S.)
HEX: 15 (For Europe)
Logic
1
000 0 mm
001 8 mm
010 12 mm
011 14 mm
100 18 mm
101 20 mm
110 24 mm
111 Not
available
000 100 %
001 95 %
010 90 %
011 85 %
100 80 %
101 65 %
110 60 %
111 Not
available
Cut off This bit determines that the received
document will be cut off with "Select
upper limit of cut off length after
printing (Bit 7 to 5)" or reduced with
"Select upper limit of reduction ratio
of received document (Bit 4 to 2)."
Description
If the excess length is
longer than specified
here:
<For reduction>
• If Bit 1 is set to 0, it is
reduced when fitting
within the reduction
percent range specified
with Bits 4 to 2.
<For division>
• If Bit 1 is set to 0, it is
divided when not fitting
within the reduction
ratio range specified
with Bits 4 to 2.
• If Bit 1 is set to 1, the
excess length portion is
divided.
Reduction will not be pro-
ceeded if a received doc-
ument is still longer than
the print paper for a spec-
ified reduction.
Y109971-7