Table of Contents
Advertisement
26
Basic operations
Switching input signals
Press the INPUT button and those signal selection buttons on the remote control or the
INPUT button on the control panel to select an input signal.
Adjusting audio volume level
Press / on the control panel or
volume.
Setting up Internet connection
Your display must be connected to the network to download updates or surf the
Internet.
Wired Connection
1. Connect one end of the Ethernet cable to the LAN port of the display.
2. Connect the other end of the Ethernet cable to the LAN port of the router.
3. Press the INPUT button on the remote control and select ANDROID.
4. On the home screen, select All Apps (
5. In the Network menu, select Wired.
6. In the Wired menu, set Open Ethernet to On to configure the network settings.
Then do the following:
- If the router setting enables obtaining IP address automatically, select The
Automatic Acquisition IP Address and press the OK button. Your display will
obtain the IP address automatically.
- Otherwise, do the following to manually configure the network:
a. Select IPv6 and press the OK button to enable/disable IPv6.
b. Select IP Address and assign a valid IP address for the device.
c. Select Subnet Mask and assign a subnet mask of the IP address for the device.
d. Select Default Gateway and assign a valid gateway for the device.
e. Select First DNS and Second DNS, and then assign a valid DNS server
address for the device.
/
on the remote control to adjust the
VOL-
VOL+
) > Settings (
) > Network.
Advertisement
Table of Contents
