Troubleshooting - Samsung SCD67/D70 Owner's Instruction Book

ENGLISH

Troubleshooting

Troubleshooting
Before contacting a service center, perform the following simple checks.
They may save you the time and expense of an unnecessary call.
Self Diagnosis Display
Display Blinking
slow
fast
slow
2MIN
no
TAPE END
slow
TAPE
TAPE slow
slow
C.EMG
D.EMG
L.EMG
R.EMG
DEW slow
Moisture Condensation
If the camcorder is brought directly from a cold place to a warm place, moisture may condense inside the camcorder, on the surface of the tape,
or on the lens. In this condition, the tape may stick to the head drum and be damaged or the unit may not operate correctly.
To prevent possible damage under these circumstances, the camcorder is fitted with a moisture sensor.
If there is moisture inside the camcorder, "DEW" is displayed.
If this happens, none of the functions except cassette ejection will work.
Open the cassette compartment and remove the battery.
Leave the camcorder for at least two hours in a dry warm room.
72
Informs that...
the battery pack is almost discharged.
the battery pack is fully discharged.
When the remaining time of the tape is about 3 minutes.
the tape reached its end.
there is no tape in camcorder.
the tape is protected to record.
the camcorder has some mechanical fault.
moisture condensation has formed in the camcorder.
Action
Change to a charged one.
Change to a charged battery.
Prepare a new one.
Change to a new one.
Insert a tape.
If you want to record, release the protection.
1. Eject the tape.
2. Set to OFF.
3. Detach the battery.
4. Reattach the battery.
* If unresolved contact your local service
representative.
see below.