Samsung SCD67/D70 Owner's Instruction Book page 70

ENGLISH
Playing back a Tape
ZERO MEMORY (SCD70 only)
The ZERO MEMORY function works in both CAMERA and PLAYER modes.
You can mark a point on a tape that you want to return to following playback.
1. Press the ZERO MEMORY button on the remote control during playback or recording at the point
you want to return to later.
The time code is changed to a tape counter that is set to zero with the
If you want to cancel the zero memory function, press the ZERO MEMORY button again.
2. Find the zero position.
When you finish playback, fast forward or rewind the tape.
– The tape stops automatically when it reaches the zero position.
When you finish recording, turn the power switch PLAYER and press the
– The tape stops automatically when it reaches the zero position.
3. The tape counter with the M
the tape counter is changed to time code.
Notes
In the following situations, the ZERO MEMORY mode may be canceled automatically
– After returning to the zero position.
– When the tape is ejected.
– When you remove the battery pack or power supply.
The zero memory may not function correctly where there is a break between recordings on the tape.
The ZERO MEMORY will not operate in DV IN mode.
66
(Zero memory indicator) disappears from the display and
M
(Zero memory indicator).
(REW) button.
SP STOP
M 0:20:00
33MIN
SP REW
M 0:10:00
43MIN
SP STOP
0:10:00:00
53MIN