Door Assembly - GE JK3800DH1BB Technical Service Manual

Door Assembly

The Door Assembly consists of the outer door glass,
liner and hinge assemblies.
Door Disassembly
1. Remove the door from the oven.
2. Place the door on a blanket or similar protective
item.
3. Remove the four 1/4 in. screws from the bottom,
and the two T20 Torx screws at the top of the
door to separate the inner panel.
4. Remove the inner door liner.
Location of Hinge Screws
Hinge Assembly
• Handle: After separating the door panels,
remove the two 1/4 in. screws that hold the
handle onto the outer door assembly.
• Hinges: After separating the door panels, the
hinges can be removed by removing the two
T20 Torx screws.
• Glass pack: With the door panels separated,
remove the ten 1/4 in. screws holding the
insulation retainer and glass pack in place.
Door Reassembly
1. Make sure that the insulation is pressed back
under the retainer when reassembling.
2. Reinstall the ten 1/4 in. screws of the insulation
retainer.
3. Reassemble the door and reinstall the four 1/4
in. screws on the bottom and the two T20 Torx
screws at the top.
– 60 –