Door Assembly; Oven Components - GE PT920 Technical Service Manual

Door Assembly

The oven door can be separated into 2 assemblies.
The outer assembly consists of the outer panel
and a replaceable door handle. The inner assembly
is made up of the inner panel, door gasket, 3
glass panels, air channel, insulation retainer, and
replaceable door hinge assemblies.
Caution: The door is very heavy. Use the correct
lifting procedure. Do not lift the door by the handle.
To remove the door:
1. Open the door fully. Pull the hinge locks down
toward the door frame, to the unlocked position.
(This may require a fl at-blade screwdriver to
start the hinge locks moving).
Slot
Hinge Lock
2. Firmly grasp both sides of the door at the top.
3. Close the door to the door removal position,
then lift it up and out.
Removal position

Oven Components

To replace the door:
1. With the door at the same angle as the removal
position, seat the indentation of the hinge arm
into the bottom edge of the hinge slot. The
notch in the hinge arm must be fully seated into
the bottom of the slot.
2. Open the door fully. If the door will not fully
open, the indentation is not seated correctly in
the bottom edge of the slot.
3. Push the hinge locks up against the front frame
of the oven cavity to the locked position.
4. Close the oven door and check for proper
alignment.
– 16 –
Bottom
Hinge
Edge of
Arm
Slot
Indentation
Hinge
Lock
Hinge Arm
Push hinge locks up to lock
(Continued next page)