Port 10Ge Otn Line Card - Cisco NCS 4016 Installation Manual

About Line Cards
Table 5-3
Attention
Port
1. The Attention LED can be lit only by using the hw-module attention-led location CLI command, which is useful for
Physical Characteristics
•
•
•
•

20-Port 10GE OTN Line Card

The 20-port 10GE OTN LC (NCS4K-20T-O-S) line card supports any combination of the following
interfaces, up to:
•
•
•
OTU1 and OTU2 ports support generic forward error correction (GFEC). The card supports up to 2-level
ODU4, ODU3, ODU2, ODU1, ODU0, and ODUFlex switching functions by interconnecting with the
centralized agnostic switch fabric.
The line card also supports direct interconnection to other slots within the Cisco NCS 4016 chassis to
interconnect switched OTN traffic directly to the NCS 4000 2 x 100G CP-DQPSK - Full C band Tunable
DWDM line card.
Figure 5-8
Cisco Network Convergence System 4000 Series Hardware Installation Guide
5-20
24-Port Low-Rate OTN LC Descriptions
1
Blue The card needs attention.
Off The card does not need attention.
Green The link is up (including internal loopback).
Yellow The link is down or a hardware failure has occurred.
Off The slice is unprovisioned by software, the optics
module is missing, or the slice has been powered
down.
identifying and verifying which card needs attention.
Height—11.05 in. (280.6 mm)
Width—1.55 in. (39.4 mm)
Depth—14.25 in. (362 mm)
Weight—5.5 lb (2.5 kg)
Twenty 10GE interfaces through SFP+ pluggable optics
Twenty OC-192/STM-64 interfaces through SFP+ pluggable optics
Twenty OTU2 interfaces through SFP+ pluggable optics
shows the details of the front panel of the 20-port 10GE OTN LC and LEDs.
Chapter 5 Installing Route Processor Cards, Fabric Cards, and Line Cards