Chapter 1 Installation Roadmap; Replacing The Front Door - Cisco NCS 4016 Installation Manual

Installation Roadmap
Table 1-1 lists the steps to install the Cisco NCS 4016 chassis and its components and prepare the system
for operation. Use this table as a checklist to ensure that all components are properly installed in the
correct order. For information about a step, see the respective book or section of this installation guide.
Table 1-1 Overview of Installation Steps
Step
Verify that the chassis is secured in the rack.
1.
For ease of installation, the cosmetic door should be
Note
removed.
2. Ground the chassis.
Verify that the power components are installed.
3.
4. Verify that the ECU is installed.
Verify that the fan trays are installed.
5.
Connect the AC or DC power cord.
6.
Power on the chassis.
7.
Install cards and remaining components in the chassis.
8.
Re-install the cosmetic door.
9.
C H A P T E R
Cisco Network Convergence System 4000 Series Hardware Installation Guide
1
See Check
Cisco Network
Convergence System
4000 Series Unpacking,
Moving, and Securing
Guide
"Installing the Chassis
Ground Cable" section
on page 4-8
Chapter 4, "Installing
Power Components"
Replacing the External
Connection Unit,
page 6-28
"Replacing the Fan
Tray" section on
page 6-23
Disconnecting AC or
DC Power, page 4-28
"Powering On the
Chassis" section on
page 4-30
Chapter 5, "Installing
Route Processor Cards,
Fabric Cards, and Line
Cards"
Replacing the Front
Door, page 6-17
1-1