Reconnecting Dc Power; Powering On The Chassis - Cisco NCS 4016 Installation Manual
Network convergence system ncs 4000 series
Hide thumbs
Also See for NCS 4016:
- Manual (24 pages) ,
- Unpacking and installing (8 pages) ,
- Hardware installation manual (82 pages)
Table of Contents
Advertisement
Powering On the Chassis
Disconnect the DC power cables from their terminals in the following order and note the color of each
Step 4
cable:
a.
b.
Repeat
Step 5
Reconnecting DC Power
To reconnect DC power to a DC power tray, see
Powering On the Chassis
Follow these steps to turn on power to an AC-powered or DC-powered chassis:
Step 1
Power on the circuit breaker to your power sources one at a time.
Verify that the correct Power Input LED on each power module in the tray is lit (one input on the LED
Step 2
flashes and both inputs on the LED are solid). Continue with steps 1 and 2 until all inputs have been
verified.
Note
Set the power tray switch for Feed A to the ON (1) position. This powers on slots PWR MOD 0 through
Step 3
PWR MOD 3.
Verify that the Power Output LED on each power module in the tray is lit.
Step 4
Repeat
Step 5
Cisco Network Convergence System 4000 Series Hardware Installation Guide
4-30
Negative (PWR) cables first.
Positive (RTN) cables last.
Step 1
through
Step 4
for the other power tray, if installed.
On the DC power tray, the Power Input LED is lit solid green if both DC feeds are valid and
blinks green if only a single DC feed is valid.
Step 3
and
Step 4
for Feed B.
Chapter 4
Connecting Power to a DC-Powered Chassis, page
Installing Power Components
4-25.
Advertisement
Table of Contents
Troubleshooting
