Table of Contents
Advertisement
Powertrain
1
6
4
2.5.1
911 GT3 Cup (991 II)
80
2.5 Drive shafts
It is recommended to run in drive shafts on new vehicles or newly fitted drive shafts
for about 50 km (31 miles) with reduced load and at max. 200 km/h (124 mph).
Only use HT 1 LF grease for lubrication when overhauling the drive shafts
3
Do not interchange used drive shafts left-right
Grease quantity for joint on wheel side:
Grease quantity for joint on gearbox side:
5
Service partner addresse: GKN Service International GmbH see chapter 7.9
2
2.5.1 Tightening instructions
1.
Tighten all bolts to 30 Nm (22.1 ft-lb) in the specified order (figure 2.5.1)
Tighten all bolts to 60 Nm (44.3 ft-lb) in the specified order (figure 2.5.1)
2.
3.
Tighten all bolts to 90 Nm (66.4 ft-lb) in the specified order (figure 2.5.1)
Lightly oil the bolts. Follow these tightening instructions whenever the drive shaft bolt
connections have been untightened.
MY 2018
150 g (5.3 ounces)
120 g (4.2 ounces)
Version: 4/20/2018
Advertisement
Table of Contents
