Juniper SRX550 Quick Start page 4

The rescue configuration is a previously committed, valid configuration. You must have
previously set the rescue configuration through the J-Web interface or the CLI.
NOTE: The Reset Config button is recessed to prevent it from being pressed
accidentally.
To press the Reset Config button, insert a small probe (such as a straightened paper clip)
into the pinhole on the front panel.
Resetting the Device to the Rescue Configuration
To reset the device to the rescue configuration, briefly press and release the Reset
Config button. The device loads and commits the rescue configuration.
Resetting the Device to the Factory Default Configuration
To reset the device to the factory default configuration, press and hold the Reset Config
button for 15 seconds or more—until the Status LED is amber and steadily on. This
action deletes all configurations on the device, including the backup configurations and
rescue configuration, and loads and commits the factory default configuration.
For more information about using the Reset Config button, including how to use it to load
and commit a previously configured rescue configuration, see the SRX550 Services
Gateway Hardware Guide at http://www.juniper.net/techpubs/a074.html .
Powering Off the Device
To shut down the operating system on the services gateway, perform a graceful
shutdown by pressing and releasing the Power button. The device begins gracefully
shutting down the operating system.
NOTE: You can reboot or halt the system in the J-Web user interface by selecting
Maintain > Reboot.
For additional configuration information, see the Branch SRX Series Services Gateways
Golden Configurations at
http://www.juniper.net/us/en/local/pdf/app-notes/3500153-en.pdf .
For detailed software configuration information, see the software documentation
available at http://www.juniper.net/techpubs/software/junos-srx/index.html .
Contacting Juniper Networks
For technical support, see http://www.juniper.net/support/requesting-support.html .
Juniper Networks, Junos, Steel-Belted Radius, NetScreen, and ScreenOS are registered trademarks of Juniper Networks, Inc. in the United States and other countries. The Juniper Networks Logo, the Junos logo, and JunosE are
trademarks of Juniper Networks, Inc. All other trademarks, service marks, registered trademarks, or registered service marks are the property of their respective owners. Juniper Networks assumes no responsibility for any inaccuracies
in this document. Juniper Networks reserves the right to change, modify, transfer, or otherwise revise this publication without notice. Products made or sold by Juniper Networks or components thereof might be covered by one or more
of the following patents that are owned by or licensed to Juniper Networks: U.S. Patent Nos. 5,473,599, 5,905,725, 5,909,440, 6,192,051, 6,333,650, 6,359,479, 6,406,312, 6,429,706, 6,459,579, 6,493,347, 6,538,518, 6,538,899,
6,552,918, 6,567,902, 6,578,186, and 6,590,785. Copyright © 2012, Juniper Networks, Inc. All rights reserved. Part Number: 530-045926 Revision 01, March 2012.